Elliots freakish proportions don't print well.
I tried to print a 3D model of his square fucking head to use as an ashtray on the Markforged Metal X at work one weekend over Christmas and I wasted more copper filament than I'm proud to admit before I gave up. His head is so wierdly proportioned it just doesn't come out looking good at all, I had a hard time getting the model to look like him so it was recognizable as him, it had to be hollow and some of the sides were too thin, and it ended up top heavy with the support struts inside, and wouldn't stand up without adding struts that made it look dumb.
I considered redesigning it to basically just be like this
View attachment 5338183
But with a cup in the top of the head, to hold the ash, but I wasted too much on it so I gave up.