Post your Kiwiler

[Homicide]

View attachment 3633129

there will never be a garf board

also I'm mad as hell that this is basically canon

 

[AsianChris]

I tried.

 

[Neo-Nazi Rich Evans]

tried my non artistic hand at making a drinking straw of fail kiwiler.

 

[K!w!Fartz]

View attachment 3634692View attachment 3634793

@Null @Null @Null
Sell these as key chains. Make them outa silicone or something!

 

[My Name is Mud]

@Null @Null @Null
Sell these as key chains. Make them outa silicone or something!

Some faggot is gonna use that as a buttplug and that's fucking horrifying.

 

[Clownish]

Finally, after 9 years in development, 3d wiggle is here! @K!w!Fartz
View attachment 3634692
Might do some more animations with him :p

Interesting...

Kiwi no! Hitler was a bad man!
View attachment 3634793

Now we just need Kiwi marching to Erika.

 

[ManicLad]

Some faggot is gonna use that as a buttplug and that's fucking horrifying.

Was just gonna say that lmao.

 

[Kookin]

Make NFTs out of it. Easy money and big waambulances from keffals and trannies alike.

 

[buttmunch]

bringing 2012 back.

View attachment 3633199

Ha yes! i was waiting for a classic loss one

 

[Kookin]

Ha yes! i was waiting for a classic loss one

View attachment 3635009

Yo this one's cute. Mind I use it on profile?

 

[buttmunch]

Yo this one's cute. Mind I use it on profile?

go for it

 

[ManicLad]

tried my non artistic hand at making a drinking star of fail kiwiler.

View attachment 3634871

9.5 out of ten. Straw needs more girth

 

[smarty_snoops]

this shit is popping off. about be the next bored ape yacht club.

 

[One Eyed Lord]

I tried.

 

[burntwater]

Ok one last one for a bit. Sorry for posting so many.

 

[Barry Macoqiner]

The supports should have been kept tree, everywhere they touched it ended up goofy, also the nose is on much better. Going to tweak and print again since it only takes 80 mins to print. Also the supports were gummy and didn't snap off I will use hatchbox pla this next time.

 

[ManicLad]

The supports should have been kept tree, everywhere they touched it ended up goofy, also the nose is on much better. Going to tweak and print again since it only takes 80 mins to print. Also the supports were gummy and didn't snap off I will use hatchbox pla this next time.

D-does it stand???

 

[Kookin]

The supports should have been kept tree, everywhere they touched it ended up goofy, also the nose is on much better. Going to tweak and print again since it only takes 80 mins to print. Also the supports were gummy and didn't snap off I will use hatchbox pla this next time.

It's quite shoddy now, but it's a step to promising merchandise.

Ha yes! i was waiting for a classic loss one

View attachment 3635009

Ey I never used a video editor in my life. Care to put this on a video on loop with music on?

 

[Barry Macoqiner]

D-does it stand???

yes even though the supports had to be ripped off with a tiny pliers it stands.

 

[veri]

have you ever seen a jace kiwiggler?