Balldoverse Meme & Edit General

  • 🐕 I am attempting to get the site runnning as fast as possible. If you are experiencing slow page load times, please report it.
From the main thread, in reference to how Barnes views how Nick is treated by the government.

1716769708016.png
 
A single horizontal cut right below where the dome connects to the two pillars and "ring", then adding alignment pegs for connection removes 90% of the support you'd need, all that would be left is the few chunks you'd need to print the dome itself.
View attachment 6035823
Honestly anyone who has a 3d printer should know how to use meshmixer and do that modification themselves so I would not worry overmuch about it.

My only suggestion would be possibly adding the Rekieta Law logo to it.
View attachment 6035829


I haven't tried meshmixer but I just installed it and give it a shot. Thanks for the advice. I'll see if I can vectorize that logo and put it on the other side.
 
I haven't tried meshmixer but I just installed it and give it a shot. Thanks for the advice. I'll see if I can vectorize that logo and put it on the other side.
I'm so fucking excited, if it's ready by the weekend I might just find the time to set up my 3d printer again. Commemorative balldos for everyone!

Also, posting my contributions from the main thread here. Should I post any other silly memes in here going forward, or do we still have amnesty to shit up the main thread? I'm new to this scale of happening.
 

Attachments

  • saythelineNick.jpg
    saythelineNick.jpg
    147.6 KB · Views: 113
  • allcuckandnosneed.jpg
    allcuckandnosneed.jpg
    67 KB · Views: 113
  • cokewi.jpg
    cokewi.jpg
    538 KB · Views: 111
Back